Principle and function of Sichuan brake holding brake

Brake lock is a common fault that can lead to vehicle brake failure or poor braking. Because the brake holds the wheel tight, so that the wheel can not turn, thus preventing travel. However, the normal brake is not locked, so in use, you should always pay attention to the condition of the brake, found that the brake should be repaired immediately.

The brake lock principle is to use the brake detection system to detect that the wheel is about to be locked when the pressure of the brake system is lowered, and the cylinder of the brake system does not have sufficient pressure, and then fails. This failure at the same time to hold the brake release, the wheel can rotate, the brake failure to solve the situation. The damage can be enormous. Because once the lock occurs, it will lose the braking function, which will not only cause damage, but also may directly endanger the life safety of passengers. In addition, it can also lead to excessive wear of tires, brakes and axle components, leading to various failures.

The brake has the characteristics of lightweight, compared with the traditional brake, the weight is smaller, easier to install, can greatly reduce the weight of the instrument, improve the reliability of the instrument. Secondly, it enjoys the characteristics of low noise, because the application of servo technology, the application of special technology, reduces friction, reduces noise, and improves the comfort of the working environment. In addition, it enjoys high reliability, adopts servo technology and applies micro-motor control to improve the reliability of the instrument, reduce the failure rate of the instrument and improve the performance of the instrument. Enjoy extraordinary performance and safe and reliable characteristics, to meet different application requirements, in the installation, commissioning, maintenance and application process, should pay attention to safety, to ensure the normal operation of the instrument, in order to maximize efficiency.

There are many reasons for brake holding, and the common reasons include the following aspects:

The quality problem itself. If the part is loose or damaged, it may cause lock. Uneven pressure. Due to the different lengths of hydraulic pipelines in different parts of the vehicle, the pressure will be unbalanced, which will lead to lock. The cylinder of the brake system is damaged. If a part of the cylinder is damaged. While there are many reasons for this, there are steps we can take to avoid it, including the following:

Check parts regularly. If any parts are found to be loose or damaged, they should be replaced in time. Avoid prolonged braking. Prolonged braking can cause overheating. Avoid driving on excessively rough roads. Excessively rough roads can have an adverse effect on the braking system.

Although brake lock is a common failure, it can be avoided by strengthening vehicle maintenance and paying attention to driving skills. In addition, in the case of brake lock, it should be handled calmly, and correct measures should be taken to eliminate the fault and ensure driving safety.