Electric forklift brake C series

Introduction of electromagnetic brakes for electric forklifts

CDC-C series brake is a spring-pressurized electromagnetic power-loss brake, mainly used in small and medium-sized electric forklift drive wheel braking, installed in the drive wheel assembly, the shaft of the drive wheel brake, so as to achieve the electric forklift parking and emergency braking, so that the user is more labor-saving, safer and more efficient!

Key features

●For deceleration brakes

●Low noise: Low brake sound

●Large corner design; Large corner steering design for more flexible operation

●Large torque with small size

●Torque range 6-16 (N. m).

● Long service life

●Using imported high wear-resistant friction plate, durable

●Meet the use of high temperature environment

●The ambient temperature of the brake is -10~+40 (°C).

●Closed design, improve the protection level

performance parameters

Size and diagram

Precautions for use

1. The brake uses more soft materials, and should avoid knocking, falling or too hard during the installation process, otherwise it may cause the brake to appear scratches or deformation and affect the use, please pay attention during the installation process.

2. Please be careful not to stretch the lead wire of the brake forcefully, bend it too much or lift the lead wire by hand, which may damage the lead wire and cause the brake to not work.

3. Our brakes are all dry double-sided friction pad brakes. If the friction surface is stained with oil or water, the torque of the brake will drop, so it needs to be used in a dry state. To prevent oil or water and dust, use a protective cover.

4. Excessive voltage fluctuations will affect the performance of the brake, so the use voltage of the brake is controlled within the range of ±10% of the rated voltage, and it is required to be smooth and interference-free.

5. The working clearance of the brake has been adjusted when leaving the factory, and there is no need to adjust it when using it, and the user is requested not to open the brake privately. Improper clearance may cause the brakes to malfunction.

6. Special attention: the brake must be opened when the motor rotates, and it is not possible to forcibly drag with the brake! Dragging with the brake will damage the brakes in a short time!

7. The installation screws are required to be fixed with thread special glue, when applying glue to the screws, please be careful not to apply to the surface of the rotor and the surface of the square wheel.

8. The installation accuracy of the brake is not good, which may cause the brake to make noise when running, please pay attention to the control. The allowable values are shown in the following table: